Step-by-step instructions to easily install your INOVATIV AXIS Weight Hanger.
Box Contents:
| (1) Weight Hanger Clamp Assembly | (2) 1/4-20 x 1/2 L |
| (1) Small Hook |
1. Using the provided hardware, install the Small Hook onto the Weight Hanger Clamp Assembly in either of the holes marked with a line.
2. Install on the adjustable rear leg of the AXIS.
⚠︎ Caution ⚠︎
Be cautious not to unwind the locking handle too far out of the weight hanger assembly or the assembly could disassemble into its individual pieces. If that happens, here is how the assembly should be reassembled:
1. Spring belongs in the hole opposite of the set screw.
2. Hold both halves together compressing the spring in the assembly until the two pieces are clamped shut.
3. Thread in the locking handle into the assembly as shown.
