Step-by-step instructions to easily install your INOVATIV AXIS Wheels and Brakes.
Box Contents:
| (1) Front Left Caster | (1) Front Right Caster |
| (1) Rear Caster |
Installation of Casters
1. Install casters as shown.
2. Tighten locking handle to secure caster to stand leg.
3. Remove knob from the caster base storage thread.
4. Install into hole as shown to lock the caster from freely swiveling. This allows the users to steer the AXIS stations more easily while moving.
Adjusting the Stand
1. Loosen the adjustment knob.
2. When the gap is .600” wide the stand will be level or standing straight up.
Note:
Because most AXIS components can be positioned on one side of the stand, the stand can tilt slightly backward to balance the weight, allowing users to level the workstation.
When the adjustment is collapsed all the way, the stand can lean backward about 2 degrees to offset any sagging of the components weighted of the front of the stand.
