Monitor Mounts
      Back to home
      1. Knowledge Base
      2. Accessories
      3. Monitor Mounts

      Instructions: Insight Monitor Mounting System for the Apollo

      Step-by-step instructions to install your INOVATIV Insight Monitor Mounting System for the Apollo workstation cart.

      These instructions are specific to the Apollo 52.  
      Apollo 40 installation is identical. Refer to page 7 for a detailed breakdown of hardware.

      Tools Needed: 3/16 Allen Key, 5/32 Allen Key

      Box Contents:

      1. (2) Insight Mast Assembly 3. (2) System Bracket
      2. (2) Insight Cross-tubes 4. (2) Pro Ultra Arm

      1. On the Apollo’s top shelf, pull the Corner Cam Lever into its “Open” position. Loosen the ¼-20 bolt located in the center of the Corner Plug using a 5/32 Allen Key.

      Screen Shot 2024-10-28 at 4.53.20 PM

      2. Slide the Removal Tool under the bolt and slowly wiggle and pull “Up” to remove the Corner Plug.

      Screen Shot 2024-10-28 at 4.54.13 PM

      3. Insert both Mast Assembly’s into the Apollo’s Corner Cam System and close the lever. 

      Screen Shot 2024-10-28 at 4.55.07 PM

      4. Remove the (4) Thumbscrews and the (2) Cross-tube Plugs on each of the (2) Mast Assemblies.

      Screen Shot 2024-10-28 at 4.55.46 PM

      5. Slide each Cross-tube into the Mast Assembly as shown.

      Screen Shot 2024-10-28 at 4.56.27 PM

      6. Loosen the System Bracket Thumbscrew’s and slide the System Brackets over the Cross-tubes. 

      Screen Shot 2024-10-28 at 4.57.06 PM

      7. Move the System Bracket on the Cross-tube by sliding the System Bracket with pressure applied around the top bushing only. Position your System Bracket where you would like the center of the Pro Ultra Arm to be connected. Once System Brackets are in their desired locations, tighten the thumbscrews by hand locking them in place. Then using the 3/16 Allen Key, secure them from any movement. Re-connect the Cross-Tube Plugs and Mast Assembly Thumbscrews, and tighten using the 3/16 Allen Key.

      Screen Shot 2024-10-28 at 4.58.10 PM

      8. Add the Pro Ultra Arm’s to the System Brackets. First insert the smaller 5/16-18 Bolt, Second the Thumbscrew. Tighten both with the supplied 3/16 Allen Key.

      Screen Shot 2024-10-28 at 5.02.18 PM

      9. Add the VESA Plate Assembly to Pro Ultra Arm, and secure with the Rubber Knob in the Lock setting if you would like to keep the monitor locked in either a vertical or horizontal position.

      Screen Shot 2024-10-28 at 5.02.50 PM

      10. Note: The 3/16 Allen Key storage area on the Pro Ultra Arm. This is where the tool should be kept.

      Screen Shot 2024-10-28 at 5.05.01 PM

      11. You are now prepared to attach your monitors and start using the Insight Monitor Mounting System.